Jiaxing Preferred Anti static Copper Foil Manufacturer
The ultra-thin copper foil, represented by mobile phones and laptops, is promoted to thin foil and ultra-thin foil types for portable electronic products, including micro buried, blind hole L multilayer boards, and BGA, CSP and other organic resin packaging substrates. At the same time, COz laser etching also requires the substrate to be extremely thin, so that the copper foil layer can be directly machined with micro wire holes. In Japan, the United States and other countries, electrolytic copper foils of 9 μ m, 5 μ m and 3/- tm can be industrialized. At present, the difficulty or key point of the production technology of ultra-thin copper foil is whether it can be directly produced without carrier, and the product qualification rate is high, as well as the development of new carriers.
Jiaxing Preferred Anti static Copper Foil Manufacturer
Copper clad laminate is the base plate for manufacturing PCB, which is an important type with large amount of materials. The manufacturing process of copper clad laminate is to impregnate glass fiber cloth, glass fiber mat, paper and other reinforcement materials with epoxy resin, phenolic resin and other adhesives, dry them to the first stage at appropriate temperature, obtain pre impregnating materials (referred to as impregnating materials), and then stack them according to process requirements and copper foil, The required copper clad laminate is obtained by heating and pressurizing on the laminator.
Jiaxing Preferred Anti static Copper Foil Manufacturer
Galvanizing barrier layer: After the rough surface is galvanized, a barrier layer is formed to improve the oxidation resistance of the copper foil in natural air. After galvanizing, the appearance will look gray. After a period of storage, the gray will turn into copper yellow. The more zinc is plated, the more yellow the copper foil will be.
Jiaxing Preferred Anti static Copper Foil Manufacturer
Copper foil can also be divided into: single-sided treatment (single-sided hair), double-sided treatment (double-sided thick), smooth treatment (double-sided hair), double-sided light copper foil (double-sided hair) and very low profile copper foil (VLP copper foil) according to the surface condition. Post copper foil can be divided into electrolytic copper foil and calendered copper foil according to different production methods.
Jiaxing Preferred Anti static Copper Foil Manufacturer
With the development of high-density wiring technology for low profile copper foil multilayer boards, the traditional type cannot meet the needs of manufacturing high-precision printed circuit boards. Therefore, a new generation of copper foils, low profile (LP) and ultra-low profile (VLP), have emerged one after another. Compared with ordinary electrolytic copper foil, LP copper foil has fine crystal (2/zm), equiaxed grains, no columnar crystals, lamellar crystals, flat prisms and low surface roughness.
Jiaxing Preferred Anti static Copper Foil Manufacturer
The production process of electrolytic copper foil is simple. There are three main processes: solution raw foil, surface treatment and product slitting. The production process seems simple, but it is a production process that integrates electronics, machinery and electrochemistry, and is particularly strict with the production environment. Therefore, the industry does not have a set of standard and universal production equipment and technology, and each manufacturer shows its own ingenuity, which is also an important bottleneck affecting the improvement of domestic production capacity and quality. In addition, the different requirements of customers have also resulted in the waste of many intermediate products copper foil in manufacturing. The one-time input-output ratio is even less than 80%, and these copper foils have to be manufactured again, wasting resources.
