Hefei Optimum Battery Copper Foil Processing
If the surface stain is caused by environmental problems, the cleaning and improvement of the air conditioning filter system should be strengthened, or the wind speed should be reduced, and the small hairs on the air conditioning filter bag must be completely removed. And the fibers and powders on the polymer materials must be completely removed, which are very easy to cause stains. The air supply pipeline is easy to use plastic material, which does not produce fiber and is easy to clean with water, acid and alkali.
Hefei Optimum Battery Copper Foil Processing
Although the thickness of copper foil gradually becomes thinner, power battery manufacturers use 6 μ When the product is less than or equal to m, the coating machine, winding machine and other key equipment as well as the technological level cannot solve the problems such as wrinkles, belt breakage and high-temperature oxidation encountered in the production process, which leads to the inability to mass produce ultra-thin copper foil with high yield.
Hefei Optimum Battery Copper Foil Processing
Copper foil is divided into calendered copper foil and electrolytic copper foil according to the preparation process, which accounts for the vast majority of the market. According to the Copper Foil Branch of China Electricity Association (CCFA), at present, domestic manufacturers mainly focus on the production of electrolytic copper foil. In 19 years, the domestic production capacity of electrolytic copper foil is expected to be close to 600000 tons, while that of rolled copper foil is only about 10000 tons.
Hefei Optimum Battery Copper Foil Processing
The commonly used reinforcement materials of copper clad laminate are alkali free (alkali metal oxide content shall not exceed 0.5%) glass fiber products (such as glass cloth, glass felt) or paper (such as wood pulp paper, bleached wood pulp paper, cotton wool paper). Therefore, laminates can be divided into glass cloth base and paper base.
Hefei Optimum Battery Copper Foil Processing
The surface of the copper foil shall be smooth and clean without obvious wrinkles, oxidation spots, scratches, pitting, pits and stains. The porosity of 305g/m2 and above shall not exceed 8 penetration points within the area of 300ram × 300mm; The total area of pores on an area of 0.5m2 shall not exceed the circular area with a diameter of 0.125mm.
