Dongguan chooses pcb copper foil price
The foil of the clad plate can be copper, nickel, aluminum and other metal foils. However, considering such factors as the conductivity, solderability, elongation, adhesion to the substrate and price of gold, it is considered appropriate except for special purposes.
Dongguan chooses pcb copper foil price
The electrolyte contains oil, paint, grease, sediment and other contaminants attached to the surface of copper foil. After being squeezed by the squeezing (water) roller, the contaminants are squeezed flat, some contaminants attach to it, and some contaminants attach to the guide roller. Because the dirt is squeezed up during the operation, the dirt has a head and a tail, and has a direction.
Dongguan chooses pcb copper foil price
Copper foil is an indispensable raw material for making printed circuit board (PCB), copper clad plate (CCL) and lithium-ion battery. For industrial use, it can be divided into calendered copper foil and two categories according to its manufacturing process. Electrolytic copper foil is made by electrolysis of copper based on electrochemical principle. The internal structure of raw foil is vertical acicular crystal structure, and its production cost is relatively low.
Dongguan chooses pcb copper foil price
Surface passivation: chromate (or chromate and zinc salt) solution is used for surface passivation (i.e. anti oxidation treatment) after the barrier layer is plated to form a complex film with chromium (or chromium zinc) as the main body on the surface, so that the copper foil will not be oxidized and discolored due to direct contact with air, and at the same time, the heat resistance of the copper foil is improved (higher zinc content, better heat resistance), The storage period of copper foil can reach 3 months.
Dongguan chooses pcb copper foil price
The ultra-thin copper foil, represented by mobile phones and laptops, is promoted to thin foil and ultra-thin foil types for portable electronic products, including micro buried, blind hole L multilayer boards, and BGA, CSP and other organic resin packaging substrates. At the same time, COz laser etching also requires the substrate to be extremely thin, so that the copper foil layer can be directly machined with micro wire holes. In Japan, the United States and other countries, electrolytic copper foils of 9 μ m, 5 μ m and 3/- tm can be industrialized. At present, the difficulty or key point of the production technology of ultra-thin copper foil is whether it can be directly produced without carrier, and the product qualification rate is high, as well as the development of new carriers.
