Qingyuan selects conductive copper foil manufacturers
If the rough surface and pinholes appear at the same time when there are stains on the rough surface, it indicates that the stains are caused by the dirty electrolyte, and the dirt is attached to the copper foil in the electrolytic cell. If there are stains on the rough surface, the copper foil is not rough and there are no pinholes, it means that the workshop production environment is dirty, the air contains dust, or other suspended impurities fall on the surface of the copper foil.
Qingyuan selects conductive copper foil manufacturers
Copper foil is divided into calendered copper foil and electrolytic copper foil according to the preparation process, which accounts for the vast majority of the market. According to the Copper Foil Branch of China Electricity Association (CCFA), at present, domestic manufacturers mainly focus on the production of electrolytic copper foil. In 19 years, the domestic production capacity of electrolytic copper foil is expected to be close to 600000 tons, while that of rolled copper foil is only about 10000 tons.
Qingyuan selects conductive copper foil manufacturers
The commonly used reinforcement materials of copper clad laminate are alkali free (alkali metal oxide content shall not exceed 0.5%) glass fiber products (such as glass cloth, glass felt) or paper (such as wood pulp paper, bleached wood pulp paper, cotton wool paper). Therefore, laminates can be divided into glass cloth base and paper base.
Qingyuan selects conductive copper foil manufacturers
Copper clad laminate is the base plate for manufacturing PCB, which is an important type with large amount of materials. The manufacturing process of copper clad laminate is to impregnate glass fiber cloth, glass fiber mat, paper and other reinforcement materials with epoxy resin, phenolic resin and other adhesives, dry them to the first stage at appropriate temperature, obtain pre impregnating materials (referred to as impregnating materials), and then stack them according to process requirements and copper foil, The required copper clad laminate is obtained by heating and pressurizing on the laminator.
