Suzhou Preferred Copper Foil Manufacturer for Heat Dissipation
If the rough surface and pinholes appear at the same time when there are stains on the rough surface, it indicates that the stains are caused by the dirty electrolyte, and the dirt is attached to the copper foil in the electrolytic cell. If there are stains on the rough surface, the copper foil is not rough and there are no pinholes, it means that the workshop production environment is dirty, the air contains dust, or other suspended impurities fall on the surface of the copper foil.
Suzhou Preferred Copper Foil Manufacturer for Heat Dissipation
The surface of the copper foil shall be smooth and clean without obvious wrinkles, oxidation spots, scratches, pitting, pits and stains. The porosity of 305g/m2 and above is required to be 300ram × No more than 8 penetration points within 300mm area; The total area of pores on an area of 0.5m2 shall not exceed the circular area with a diameter of 0.125mm.
Suzhou Preferred Copper Foil Manufacturer for Heat Dissipation
Excellent tensile strength and elongation High tensile strength and elongation under normal conditions can improve processing ability, enhance rigidity and avoid wrinkles to improve production qualification rate. High temperature extensibility (THE) copper foil and high tensile strength copper foil at high temperature can improve the thermal stability of printed boards and avoid deformation and warpage.
Suzhou Preferred Copper Foil Manufacturer for Heat Dissipation
Small dirt, small exclamation mark. During the production of raw foil, the hair side is upward, and the dirt in liquid and air all fall on the hair side, which is printed on the smooth side after rolling. The reason is that the stains on the cathode roll are not dried. The surface temperature of the cathode roll is only 50 degrees, and the air temperature in the workshop is generally about 25 degrees. The surface hairiness is very good. The dirt itself has water, and the drying time is only 2-3 minutes. Therefore, the dirt on the copper foil cannot be completely dried.
Suzhou Preferred Copper Foil Manufacturer for Heat Dissipation
Copper foil is not a traditional metal copper product. It combines design concepts such as composite material and nano material technology, and different internal microstructures, resulting in different properties from traditional pure copper. The application of copper foil mainly focuses on the characteristics of conduction, heat conduction and electromagnetic wave shielding.
Suzhou Preferred Copper Foil Manufacturer for Heat Dissipation
Calendered copper foil is a product made by repeatedly rolling and annealing high-precision copper strip (usually less than 150 microns in thickness) based on the principle of plastic processing (usually 4-100 microns in thickness and<800 mm in width). Its ductility, bending resistance and conductivity are better than those of electrolytic copper foil, and the copper purity is also higher than that of electrolytic copper foil.
