Jiujiang Preferred Rolling Copper Foil Manufacturer
The adhesives used for the laminates mainly include phenolic, epoxy, polyester, polyimide, polytetrafluoroethylene resin, etc. Therefore, the laminates are also divided into phenolic, epoxy, polyester, polyimide, and polytetrafluoroethylene laminates.
Jiujiang Preferred Rolling Copper Foil Manufacturer
With the development of high-density wiring technology for low profile copper foil multilayer boards, the traditional type cannot meet the needs of manufacturing high-precision printed circuit boards. Therefore, a new generation of copper foils, low profile (LP) and ultra-low profile (VLP), have emerged one after another. Compared with ordinary electrolytic copper foil, LP copper foil has fine crystal (2/zm), equiaxed grains, no columnar crystals, lamellar crystals, flat prisms and low surface roughness.
Jiujiang Preferred Rolling Copper Foil Manufacturer
Most copper foils used for domestic printed boards are 35um thick, and 50um copper foils are used as transition products. In high-precision hole metallized double-sided or multilayer board manufacturing, thinner than 35um copper foils, such as 18um, 9um and 5um copper foils, are expected. Some multilayer boards use thicker copper foil, such as 70um.
Jiujiang Preferred Rolling Copper Foil Manufacturer
The surface of the copper foil shall be smooth and clean without obvious wrinkles, oxidation spots, scratches, pitting, pits and stains. The porosity of 305g/m2 and above shall not exceed 8 penetration points within the area of 300ram × 300mm; The total area of pores on an area of 0.5m2 shall not exceed the circular area with a diameter of 0.125mm.
Jiujiang Preferred Rolling Copper Foil Manufacturer
The copper foil industry belongs to the copper processing industry, which processes copper into extremely thin copper strips or sheets by means of rolling, electrolysis and sputtering, and further applies them as industrial raw materials in various downstream products. The thickness of μ Below m, the thickness varies depending on the scene used.
