Beijing Optimum Battery Copper Foil Processing
Although the thickness of copper foil gradually becomes thinner, power battery manufacturers use 6 μ When the product is less than or equal to m, the coating machine, winding machine and other key equipment as well as the technological level cannot solve the problems such as wrinkles, belt breakage and high-temperature oxidation encountered in the production process, which leads to the inability to mass produce ultra-thin copper foil with high yield.
Beijing Optimum Battery Copper Foil Processing
Calendered copper foil is the original foil made from copper plate by repeated rolling, and then roughened according to requirements. Due to the limitation of processing technology, its width is difficult to meet the requirements of rigid copper clad laminate, so calendered copper foil is rarely used on rigid copper clad laminate; However, because the bending resistance and elastic coefficient are greater than electrolytic copper foil, they are often used on flexible copper clad laminate.
Beijing Optimum Battery Copper Foil Processing
Most copper foils used for domestic printed boards are 35um thick, and 50um copper foils are used as transition products. In high-precision hole metallized double-sided or multilayer board manufacturing, thinner than 35um copper foils, such as 18um, 9um and 5um copper foils, are expected. Some multilayer boards use thicker copper foil, such as 70um.
Beijing Optimum Battery Copper Foil Processing
Copper foil is divided into calendered copper foil and electrolytic copper foil according to the preparation process, which accounts for the vast majority of the market. According to the Copper Foil Branch of China Electricity Association (CCFA), at present, domestic manufacturers mainly focus on the production of electrolytic copper foil. In 19 years, the domestic production capacity of electrolytic copper foil is expected to be close to 600000 tons, while that of rolled copper foil is only about 10000 tons.
Beijing Optimum Battery Copper Foil Processing
Small dirt, small exclamation mark. During the production of raw foil, the hair side is upward, and the dirt in liquid and air all fall on the hair side, which is printed on the smooth side after rolling. The reason is that the stains on the cathode roll are not dried. The surface temperature of the cathode roll is only 50 degrees, and the air temperature in the workshop is generally about 25 degrees. The surface hairiness is very good. The dirt itself has water, and the drying time is only 2-3 minutes. Therefore, the dirt on the copper foil cannot be completely dried.
Beijing Optimum Battery Copper Foil Processing
The production process of electrolytic copper foil is simple. There are three main processes: solution raw foil, surface treatment and product slitting. The production process seems simple, but it is a production process that integrates electronics, machinery and electrochemistry, and is particularly strict with the production environment. Therefore, the industry does not have a set of standard and universal production equipment and technology, and each manufacturer shows its own ingenuity, which is also an important bottleneck affecting the improvement of domestic production capacity and quality.
