Shaoxing Preferred Electronic Copper Foil Price
Small dirt, small exclamation mark. During the production of raw foil, the hair side is upward, and the dirt in liquid and air all fall on the hair side, which is printed on the smooth side after rolling. The reason is that the stains on the cathode roll are not dried. The surface temperature of the cathode roll is only 50 degrees, and the air temperature in the workshop is generally about 25 degrees. The surface hairiness is very good. The dirt itself has water, and the drying time is only 2-3 minutes. Therefore, the dirt on the copper foil cannot be completely dried.
Shaoxing Preferred Electronic Copper Foil Price
Foil making material requirements: the thinner the thickness is, the higher the quality grade is, and the lower the impurity content in the electrolyte is required. In order to ensure the quality, the purity of copper must be greater than 99.9%.
Shaoxing Preferred Electronic Copper Foil Price
Surface passivation: chromate (or chromate and zinc salt) solution is used for surface passivation (i.e. anti oxidation treatment) after the barrier layer is plated to form a complex film with chromium (or chromium zinc) as the main body on the surface, so that the copper foil will not be oxidized and discolored due to direct contact with air, and at the same time, the heat resistance of the copper foil is improved (higher zinc content, better heat resistance), The storage period of copper foil can reach 3 months.
Shaoxing Preferred Electronic Copper Foil Price
Most copper foils used for domestic printed boards are 35um thick, and 50um copper foils are used as transition products. In high-precision hole metallized double-sided or multilayer board manufacturing, thinner than 35um copper foils, such as 18um, 9um and 5um copper foils, are expected. Some multilayer boards use thicker copper foil, such as 70um.
Shaoxing Preferred Electronic Copper Foil Price
The electrolyte contains oil, paint, grease, sediment and other contaminants attached to the surface of copper foil. After being squeezed by the squeezing (water) roller, the contaminants are squeezed flat, some contaminants attach to it, and some contaminants attach to the guide roller. Because the dirt is squeezed up during the operation, the dirt has a head and a tail, and has a direction.
Shaoxing Preferred Electronic Copper Foil Price
The ultra-thin copper foil, represented by mobile phones and laptops, is promoted to thin foil and ultra-thin foil types for portable electronic products, including micro buried, blind hole L multilayer boards, and BGA, CSP and other organic resin packaging substrates. At the same time, COz laser etching also requires the substrate to be extremely thin, so that the copper foil layer can be directly machined with micro wire holes. In Japan, the United States and other countries, electrolytic copper foils of 9 μ m, 5 μ m and 3/- tm can be industrialized. At present, the difficulty or key point of the production technology of ultra-thin copper foil is whether it can be directly produced without carrier, and the product qualification rate is high, as well as the development of new carriers.
