Ganzhou Chosen Electrolytic Copper Foil Manufacturers
Small dirt, small exclamation mark. During the production of raw foil, the hair side is upward, and the dirt in liquid and air all fall on the hair side, which is printed on the smooth side after rolling. The reason is that the stains on the cathode roll are not dried. The surface temperature of the cathode roll is only 50 degrees, and the air temperature in the workshop is generally about 25 degrees. The surface hairiness is very good. The dirt itself has water, and the drying time is only 2-3 minutes. Therefore, the dirt on the copper foil cannot be completely dried.
Ganzhou Chosen Electrolytic Copper Foil Manufacturers
The surface of the copper foil shall be smooth and clean without obvious wrinkles, oxidation spots, scratches, pitting, pits and stains. The porosity of 305g/m2 and above shall not exceed 8 penetration points within the area of 300ram × 300mm; The total area of pores on an area of 0.5m2 shall not exceed the circular area with a diameter of 0.125mm.
Ganzhou Chosen Electrolytic Copper Foil Manufacturers
Copper foil can be divided into calendered copper foil and electrolytic copper foil, which are mainly used for flexible printed circuits and other special purposes. In the production of clad laminates, a large number of applications are. As for the purity of copper, IEC-249-34 and Chinese standards stipulate that it shall not be lower than 99.8%.
Ganzhou Chosen Electrolytic Copper Foil Manufacturers
The copper clad laminate is composed of copper foil, reinforcement material and adhesive. Plates are usually classified according to the reinforcement material category and adhesive category or plate characteristics.
Ganzhou Chosen Electrolytic Copper Foil Manufacturers
Copper foil is divided into calendered copper foil and electrolytic copper foil according to the preparation process, which accounts for the vast majority of the market. According to the Copper Foil Branch of China Electricity Association (CCFA), at present, domestic manufacturers mainly focus on the production of electrolytic copper foil. In 19 years, the domestic production capacity of electrolytic copper foil is expected to be close to 600000 tons, while that of rolled copper foil is only about 10000 tons.
