Wuhu optimal heat dissipation copper foil processing
High end lithium battery copper foil needs to meet the requirements of high energy density, high safety, lightweight and other characteristics of power batteries, which is also the development trend of power batteries in the future. In order to meet the above characteristics, thinner lithium copper foil means smaller resistance, so the energy density and other performance of the battery will be improved. Moreover, the thinner the copper foil of lithium battery is, the lighter the weight of the corresponding battery will be.
Wuhu optimal heat dissipation copper foil processing
At the same time of thinning, it is also necessary to improve the tensile strength, elongation and other indicators, otherwise it is easy to cause copper foil fracture, affecting the safety of the battery. Therefore, it is the general trend that the future use will be more light and meet the above indicators.
Wuhu optimal heat dissipation copper foil processing
In order to avoid the copper oxide powder falling off and moving to the substrate, the surface treatment method has also been constantly improved. For example, TW copper foil is coated with a thin layer of zinc on the roughened surface of the copper foil, and the surface is gray; TC type copper foil is coated with a thin layer of copper zinc alloy on the roughened surface of the copper foil. At this time, the surface of the copper foil is golden yellow. After special treatment, the thermal discoloration resistance, oxidation resistance and cyanide resistance of copper foil in PCB manufacturing are improved accordingly.
Wuhu optimal heat dissipation copper foil processing
Copper foil is an indispensable raw material for making printed circuit board (PCB), copper clad plate (CCL) and lithium-ion battery. For industrial use, it can be divided into calendered copper foil and two categories according to its manufacturing process. Electrolytic copper foil is made by electrolysis of copper based on electrochemical principle. The internal structure of raw foil is vertical acicular crystal structure, and its production cost is relatively low.
Wuhu optimal heat dissipation copper foil processing
The surface of the copper foil shall be smooth and clean without obvious wrinkles, oxidation spots, scratches, pitting, pits and stains. The porosity of 305g/m2 and above is required to be 300ram × No more than 8 penetration points within 300mm area; The total area of pores on an area of 0.5m2 shall not exceed the circular area with a diameter of 0.125mm.
