Hangzhou Optimized Ultra thin Copper Foil Processing
According to the burning degree of the substrate in the flame and after leaving the ignition source, it can be divided into general type and self extinguishing type; According to the bending degree of the substrate, it can be divided into rigid and flexible laminates; According to the working temperature and working environment conditions of the substrate, it can be divided into heat resistant, radiation resistant, high-frequency foil clad plate, etc. In addition, there are also laminates used in special occasions, such as prefabricated inner laminates, metal based laminates, and copper foil, nickel foil, silver foil, aluminum foil, Kang copper foil, beryllium copper foil laminates according to the type of foil.
Hangzhou Optimized Ultra thin Copper Foil Processing
Calendered copper foil is the original foil made from copper plate by repeated rolling, and then roughened according to requirements. Due to the limitation of processing technology, its width is difficult to meet the requirements of rigid copper clad laminate, so calendered copper foil is rarely used on rigid copper clad laminate; However, because the bending resistance and elastic coefficient are greater than electrolytic copper foil, they are often used on flexible copper clad laminate.
Hangzhou Optimized Ultra thin Copper Foil Processing
Foil making material requirements: the thinner the thickness is, the higher the quality grade is, and the lower the impurity content in the electrolyte is required. In order to ensure the quality, the purity of copper must be greater than 99.9%.
Hangzhou Optimized Ultra thin Copper Foil Processing
If the rough surface and pinholes appear at the same time when there are stains on the rough surface, it indicates that the stains are caused by the dirty electrolyte, and the dirt is attached to the copper foil in the electrolytic cell. If there are stains on the rough surface, the copper foil is not rough and there are no pinholes, it means that the workshop production environment is dirty, the air contains dust, or other suspended impurities fall on the surface of the copper foil.
Hangzhou Optimized Ultra thin Copper Foil Processing
Silane coupling agent treatment: after anti oxidation treatment, the surface is sprayed with silane, which can improve the oxidation resistance at room temperature on the one hand; On the other hand, in high temperature pressing plate, silane can better combine copper foil and resin substrate through coupling, and improve peel strength. Post treatment process - drying. In order to prevent the harm of residual moisture, it must be dried at not less than 100 ℃ later, and the drying temperature cannot be too high.
