Ningbo Preferred Antenna Copper Foil Price
Copper foil is an indispensable raw material for making printed circuit board (PCB), copper clad plate (CCL) and lithium-ion battery. For industrial use, it can be divided into calendered copper foil and two categories according to its manufacturing process. Electrolytic copper foil is made by electrolysis of copper based on electrochemical principle. The internal structure of raw foil is vertical acicular crystal structure, and its production cost is relatively low.
Ningbo Preferred Antenna Copper Foil Price
Small dirt, small exclamation mark. During the production of raw foil, the hair side is upward, and the dirt in liquid and air all fall on the hair side, which is printed on the smooth side after rolling. The reason is that the stains on the cathode roll are not dried. The surface temperature of the cathode roll is only 50 degrees, and the air temperature in the workshop is generally about 25 degrees. The surface hairiness is very good. The dirt itself has water, and the drying time is only 2-3 minutes. Therefore, the dirt on the copper foil cannot be completely dried.
Ningbo Preferred Antenna Copper Foil Price
Electrolytic copper foil is made by dissolving copper into copper sulfate solution, electrodepositing the copper sulfate electrolyte under the action of direct current in special electrolytic equipment to make the original foil, and then carrying out surface treatment, heat-resistant layer treatment, oxidation prevention treatment and other surface treatment processes on the original foil according to customer requirements.
Ningbo Preferred Antenna Copper Foil Price
The electrolyte contains oil, paint, grease, sediment and other contaminants attached to the surface of copper foil. After being squeezed by the squeezing (water) roller, the contaminants are squeezed flat, some contaminants attach to it, and some contaminants attach to the guide roller. Because the dirt is squeezed up during the operation, the dirt has a head and a tail, and has a direction.
