Copper foil processing of Suzhou Preferred Antenna
Electronic circuit copper foil plays an important role in conducting electricity and heat in printed circuit board (PCB), and is known as the neural network on PCB. At present, copper foil for electronic circuits (PCB copper foil) is divided into two categories, namely conventional copper foil and high-performance copper foil.
Copper foil processing of Suzhou Preferred Antenna
Calendered copper foil is the original foil made from copper plate by repeated rolling, and then roughened according to requirements. Due to the limitation of processing technology, its width is difficult to meet the requirements of rigid copper clad laminate, so calendered copper foil is rarely used on rigid copper clad laminate; However, because the bending resistance and elastic coefficient are greater than electrolytic copper foil, they are often used on flexible copper clad laminate.
Copper foil processing of Suzhou Preferred Antenna
The production process of electrolytic copper foil is simple. There are three main processes: solution raw foil, surface treatment and product slitting. The production process seems simple, but it is a production process that integrates electronics, machinery and electrochemistry, and is particularly strict with the production environment. Therefore, the industry does not have a set of standard and universal production equipment and technology, and each manufacturer shows its own ingenuity, which is also an important bottleneck affecting the improvement of domestic production capacity and quality.
Copper foil processing of Suzhou Preferred Antenna
Silane coupling agent treatment: after anti oxidation treatment, the surface is sprayed with silane, which can improve the oxidation resistance at room temperature on the one hand; On the other hand, in high temperature pressing plate, silane can better combine copper foil and resin substrate through coupling, and improve peel strength. Post treatment process - drying. In order to prevent the harm of residual moisture, it must be dried at not less than 100 ℃ later, and the drying temperature cannot be too high.
Copper foil processing of Suzhou Preferred Antenna
The air supply of general air conditioning has a large impact. For the stains caused by the dirty electrolyte, the filtering of electrolyte should be strengthened. After being transferred from the electrolytic cell, the copper foil must be washed with electrolyte, because the surface of the copper foil is attached with organic matter or other impurities. The water pressure of copper foil washing must have enough pressure and a certain amount of water.
Copper foil processing of Suzhou Preferred Antenna
According to the burning degree of the substrate in the flame and after leaving the ignition source, it can be divided into general type and self extinguishing type; According to the bending degree of the substrate, it can be divided into rigid and flexible laminates; According to the working temperature and working environment conditions of the substrate, it can be divided into heat resistant, radiation resistant, high-frequency foil clad plate, etc. In addition, there are also laminates used in special occasions, such as prefabricated inner laminates, metal based laminates, and copper foil, nickel foil, silver foil, aluminum foil, Kang copper foil, beryllium copper foil laminates according to the type of foil.
