Xuancheng Preferred Electronic Copper Foil Manufacturer
Foil making material requirements: the thinner the thickness is, the higher the quality grade is, and the lower the impurity content in the electrolyte is required. In order to ensure the quality, the purity of copper must be greater than 99.9%.
Xuancheng Preferred Electronic Copper Foil Manufacturer
Calendered copper foil is a product made by repeatedly rolling and annealing high-precision copper strip (usually less than 150 microns in thickness) based on the principle of plastic processing (usually 4-100 microns in thickness and<800 mm in width). Its ductility, bending resistance and conductivity are better than those of electrolytic copper foil, and the copper purity is also higher than that of electrolytic copper foil.
Xuancheng Preferred Electronic Copper Foil Manufacturer
If the rough surface and pinholes appear at the same time when there are stains on the rough surface, it indicates that the stains are caused by the dirty electrolyte, and the dirt is attached to the copper foil in the electrolytic cell. If there are stains on the rough surface, the copper foil is not rough and there are no pinholes, it means that the workshop production environment is dirty, the air contains dust, or other suspended impurities fall on the surface of the copper foil.
Xuancheng Preferred Electronic Copper Foil Manufacturer
During the production of copper foil, tiny foreign matters are adhered on the surface to form spots with different colors from the surface, which are called stains. Judgment method: use macroscopic inspection to judge whether it is a waste product, a secondary product or a finished product according to the number and area of stains and the impact on product quality.
Xuancheng Preferred Electronic Copper Foil Manufacturer
The electrolyte contains oil, paint, grease, sediment and other contaminants attached to the surface of copper foil. After being squeezed by the squeezing (water) roller, the contaminants are squeezed flat, some contaminants attach to it, and some contaminants attach to the guide roller. Because the dirt is squeezed up during the operation, the dirt has a head and a tail, and has a direction.
