Shaoxing Preferred Copper Foil Price
With the development of high-density wiring technology for low profile copper foil multilayer boards, the traditional type cannot meet the needs of manufacturing high-precision printed circuit boards. Therefore, a new generation of copper foils, low profile (LP) and ultra-low profile (VLP), have emerged one after another. Compared with ordinary electrolytic copper foil, LP copper foil has fine crystal (2/zm), equiaxed grains, no columnar crystals, lamellar crystals, flat prisms and low surface roughness.
Shaoxing Preferred Copper Foil Price
If the rough surface and pinholes appear at the same time when there are stains on the rough surface, it indicates that the stains are caused by the dirty electrolyte, and the dirt is attached to the copper foil in the electrolytic cell. If there are stains on the rough surface, the copper foil is not rough and there are no pinholes, it means that the workshop production environment is dirty, the air contains dust, or other suspended impurities fall on the surface of the copper foil.
Shaoxing Preferred Copper Foil Price
Silane coupling agent treatment: after anti oxidation treatment, the surface is sprayed with silane, which can improve the oxidation resistance at room temperature on the one hand; On the other hand, in high temperature pressing plate, silane can better combine copper foil and resin substrate through coupling, and improve peel strength. Post treatment process - drying. In order to prevent the harm of residual moisture, it must be dried at not less than 100 ℃ later, and the drying temperature cannot be too high.
Shaoxing Preferred Copper Foil Price
Copper clad laminate is the base plate for manufacturing PCB, which is an important type with large amount of materials. The manufacturing process of copper clad laminate is to impregnate glass fiber cloth, glass fiber mat, paper and other reinforcement materials with epoxy resin, phenolic resin and other adhesives, dry them to the first stage at appropriate temperature, obtain pre impregnating materials (referred to as impregnating materials), and then stack them according to process requirements and copper foil, The required copper clad laminate is obtained by heating and pressurizing on the laminator.
Shaoxing Preferred Copper Foil Price
Most copper foils used for domestic printed boards are 35um thick, and 50um copper foils are used as transition products. In high-precision hole metallized double-sided or multilayer board manufacturing, thinner than 35um copper foils, such as 18um, 9um and 5um copper foils, are expected. Some multilayer boards use thicker copper foil, such as 70um.
Shaoxing Preferred Copper Foil Price
Copper foil can be divided into calendered copper foil and electrolytic copper foil, which are mainly used for flexible printed circuits and other special purposes. In the production of clad laminates, a large number of applications are. As for the purity of copper, IEC-249-34 and Chinese standards stipulate that it shall not be lower than 99.8%.
