Quzhou Preferred Circuit Board Copper Foil Manufacturer
The technical feature of electrolytic copper foil is that various technical conditions in electrolyte and additives must be strictly controlled, so equipment alone is not enough to produce high-performance copper foil; High performance has high requirements for the materials of anode plate and cathode roll in the raw foil equipment, the processing accuracy and consistency of the equipment; In the production process, the concentration of copper and acid in the electrolyte needs to be monitored and adjusted in real time.
Quzhou Preferred Circuit Board Copper Foil Manufacturer
In order to improve the bonding strength of copper foil to the substrate, oxidation is usually used (that is, after oxidation treatment, a layer of copper oxide or cuprous oxide is formed on the surface, which improves the bonding strength of copper foil and substrate due to the polarity) Or roughen the copper foil (a roughened layer is generated on the surface of the copper foil by electrochemical method, which increases the surface area of the copper foil and improves the bonding strength between the copper foil and the substrate due to the anchoring effect of the roughened layer on the substrate).
Quzhou Preferred Circuit Board Copper Foil Manufacturer
The copper foil industry belongs to the copper processing industry, which processes copper into extremely thin copper strips or sheets by means of rolling, electrolysis and sputtering, and further applies them as industrial raw materials in various downstream products. The thickness of μ Below m, the thickness varies depending on the scene used.
Quzhou Preferred Circuit Board Copper Foil Manufacturer
The adhesives used for the laminates mainly include phenolic, epoxy, polyester, polyimide, polytetrafluoroethylene resin, etc. Therefore, the laminates are also divided into phenolic, epoxy, polyester, polyimide, and polytetrafluoroethylene laminates.
Quzhou Preferred Circuit Board Copper Foil Manufacturer
The surface of the copper foil shall be smooth and clean without obvious wrinkles, oxidation spots, scratches, pitting, pits and stains. The porosity of 305g/m2 and above shall not exceed 8 penetration points within the area of 300ram × 300mm; The total area of pores on an area of 0.5m2 shall not exceed the circular area with a diameter of 0.125mm.
