Zhuhai Preferred Double Lead Copper Foil Price
In order to avoid the copper oxide powder falling off and moving to the substrate, the surface treatment method has also been constantly improved. For example, TW copper foil is coated with a thin layer of zinc on the roughened surface of the copper foil, and the surface is gray; TC type copper foil is coated with a thin layer of copper zinc alloy on the roughened surface of the copper foil. At this time, the surface of the copper foil is golden yellow. After special treatment, the thermal discoloration resistance, oxidation resistance and cyanide resistance of copper foil in PCB manufacturing are improved accordingly.
Zhuhai Preferred Double Lead Copper Foil Price
Electronic circuit copper foil plays an important role in conducting electricity and heat in printed circuit board (PCB), and is known as the neural network on PCB. At present, copper foil for electronic circuits (PCB copper foil) is divided into two categories, namely conventional copper foil and high-performance copper foil.
Zhuhai Preferred Double Lead Copper Foil Price
The adhesives used for the laminates mainly include phenolic, epoxy, polyester, polyimide, polytetrafluoroethylene resin, etc. Therefore, the laminates are also divided into phenolic, epoxy, polyester, polyimide, and polytetrafluoroethylene laminates.
Zhuhai Preferred Double Lead Copper Foil Price
Small dirt, small exclamation mark. During the production of raw foil, the hair side is upward, and the dirt in liquid and air all fall on the hair side, which is printed on the smooth side after rolling. The reason is that the stains on the cathode roll are not dried. The surface temperature of the cathode roll is only 50 degrees, and the air temperature in the workshop is generally about 25 degrees. The surface hairiness is very good. The dirt itself has water, and the drying time is only 2-3 minutes. Therefore, the dirt on the copper foil cannot be completely dried.
Zhuhai Preferred Double Lead Copper Foil Price
The surface of the copper foil shall be smooth and clean without obvious wrinkles, oxidation spots, scratches, pitting, pits and stains. The porosity of 305g/m2 and above shall not exceed 8 penetration points within the area of 300ram × 300mm; The total area of pores on an area of 0.5m2 shall not exceed the circular area with a diameter of 0.125mm.
Zhuhai Preferred Double Lead Copper Foil Price
Copper foil is divided into calendered copper foil and electrolytic copper foil according to the preparation process, which accounts for the vast majority of the market. According to the Copper Foil Branch of China Electricity Association (CCFA), at present, domestic manufacturers mainly focus on the production of electrolytic copper foil. In 19 years, the domestic production capacity of electrolytic copper foil is expected to be close to 600000 tons, while that of rolled copper foil is only about 10000 tons.
