Nantong Preferred Copper Foil Manufacturer
The production process of electrolytic copper foil is simple. There are three main processes: solution raw foil, surface treatment and product slitting. The production process seems simple, but it is a production process that integrates electronics, machinery and electrochemistry, and is particularly strict with the production environment. Therefore, the industry does not have a set of standard and universal production equipment and technology, and each manufacturer shows its own ingenuity, which is also an important bottleneck affecting the improvement of domestic production capacity and quality. In addition, the different requirements of customers have also resulted in the waste of many intermediate products copper foil in manufacturing. The one-time input-output ratio is even less than 80%, and these copper foils have to be manufactured again, wasting resources.
Nantong Preferred Copper Foil Manufacturer
The electrolyte contains oil, paint, grease, sediment and other contaminants attached to the surface of copper foil. After being squeezed by the squeezing (water) roller, the contaminants are squeezed flat, some contaminants attach to it, and some contaminants attach to the guide roller. Because the dirt is squeezed up during the operation, the dirt has a head and a tail, and has a direction.
Nantong Preferred Copper Foil Manufacturer
Copper foil is a key conductive material in lithium ion batteries and printed circuit boards. It is a kind of negative electrolytic material, a thin, continuous metal foil deposited on the substrate of circuit board.
Nantong Preferred Copper Foil Manufacturer
If the rough surface and pinholes appear at the same time when there are stains on the rough surface, it indicates that the stains are caused by the dirty electrolyte, and the dirt is attached to the copper foil in the electrolytic cell. If there are stains on the rough surface, the copper foil is not rough and there are no pinholes, it means that the workshop production environment is dirty, the air contains dust, or other suspended impurities fall on the surface of the copper foil.
Nantong Preferred Copper Foil Manufacturer
Backward key production equipment: for high-quality products with production thickness less than 0.05mm, multi roll rolling mill with width meeting user requirements shall be used. The rolling mill of some domestic copper processing plants can not be normally put into rolling foil production due to the lack of other equipment or the traditional product structure in the factory. However, some small processing plants have to use outdated production equipment and processes due to lack of key equipment or investment capacity, and copper foil product specifications and technical indicators are inferior to foreign products.
