Lishui selects electrolytic copper foil manufacturers
Copper foil is a key conductive material in lithium ion batteries and printed circuit boards. It is a kind of negative electrolytic material, a thin, continuous metal foil deposited on the substrate of circuit board.
Lishui selects electrolytic copper foil manufacturers
If the surface stain is caused by environmental problems, the cleaning and improvement of the air conditioning filter system should be strengthened, or the wind speed should be reduced, and the small hairs on the air conditioning filter bag must be completely removed. And the fibers and powders on the polymer materials must be completely removed, which are very easy to cause stains. The air supply pipeline is easy to use plastic material, which does not produce fiber and is easy to clean with water, acid and alkali.
Lishui selects electrolytic copper foil manufacturers
Definition of electrolytic copper foil: it is formed by depositing copper ions in electrolyte on the round cathode roller of smooth rotating stainless steel plate (or titanium plate). The surface close to the cathode roller is called smooth surface, and the other surface is called rough surface.
Lishui selects electrolytic copper foil manufacturers
The surface of the copper foil shall be smooth and clean without obvious wrinkles, oxidation spots, scratches, pitting, pits and stains. The porosity of 305g/m2 and above shall not exceed 8 penetration points within the area of 300ram × 300mm; The total area of pores on an area of 0.5m2 shall not exceed the circular area with a diameter of 0.125mm.
Lishui selects electrolytic copper foil manufacturers
Small dirt, small exclamation mark. During the production of raw foil, the hair side is upward, and the dirt in liquid and air all fall on the hair side, which is printed on the smooth side after rolling. The reason is that the stains on the cathode roll are not dried. The surface temperature of the cathode roll is only 50 degrees, and the air temperature in the workshop is generally about 25 degrees. The surface hairiness is very good. The dirt itself has water, and the drying time is only 2-3 minutes. Therefore, the dirt on the copper foil cannot be completely dried.
