Chuzhou preferred battery copper foil processing
At the same time of thinning, it is also necessary to improve the tensile strength, elongation and other indicators, otherwise it is easy to cause copper foil fracture, affecting the safety of the battery. Therefore, it is the general trend that the future use will be more light and meet the above indicators.
Chuzhou preferred battery copper foil processing
Copper foil can be divided into many kinds according to different classifications. According to the thickness, it can be divided into: thickness (more than 70 μ m) Regular thickness copper foil (more than 18 μ M but less than 70 μ m) Thin copper foil (more than 12 μ M but less than 18 μ m) Ultra thin copper foil (less than 12 μ m) Etc.
Chuzhou preferred battery copper foil processing
Small dirt, small exclamation mark. During the production of raw foil, the hair side is upward, and the dirt in liquid and air all fall on the hair side, which is printed on the smooth side after rolling. The reason is that the stains on the cathode roll are not dried. The surface temperature of the cathode roll is only 50 degrees, and the air temperature in the workshop is generally about 25 degrees. The surface hairiness is very good. The dirt itself has water, and the drying time is only 2-3 minutes. Therefore, the dirt on the copper foil cannot be completely dried.
Chuzhou preferred battery copper foil processing
The surface of the copper foil shall be smooth and clean without obvious wrinkles, oxidation spots, scratches, pitting, pits and stains. The porosity of 305g/m2 and above shall not exceed 8 penetration points within the area of 300ram × 300mm; The total area of pores on an area of 0.5m2 shall not exceed the circular area with a diameter of 0.125mm.
Chuzhou preferred battery copper foil processing
Ultra thin copper foil is used for portable electronic products such as mobile phones and laptops. Multilayer boards containing micro buried and blind vials and BGA, CSP and other organic resin packaging substrates are used to promote thin foil and ultra-thin foil. At the same time, COz laser etching also requires the substrate to be extremely thin, so that the copper foil layer can be directly machined with micro wire holes. In Japan, the United States and other countries, electrolytic copper foils of 9 μ m, 5 μ m and 3/- tm can be industrialized. At present, the difficulty or key point of the production technology of ultra-thin copper foil is whether it can be directly produced without carrier, and the product qualification rate is high, as well as the development of new carriers.
Chuzhou preferred battery copper foil processing
Copper foil can also be divided into: single-sided treatment (single-sided hair), double-sided treatment (double-sided thick), smooth treatment (double-sided hair), double-sided light copper foil (double-sided hair) and very low profile copper foil (VLP copper foil) according to the surface condition. Post copper foil can be divided into electrolytic copper foil and calendered copper foil according to different production methods.
